James Bateman (hp-laptop)
58475386ba
ESP32 firmware bridging the 1550 nm MOPA (Koheron CTL200 seed + Agiltron M511 two-stage EDFA) to MQTT/HA as a single device. Telemetry and control for both instruments verified end-to-end: MQTT command -> seed lasing -> booster ramp to 27 dBm (~515 mW) at the documented 2500 mA operating point. - PlatformIO/Arduino project, project-local venv, Makefile upload flow - Koheron ASCII driver on UART2; Agiltron binary 0x55AA driver on UART1 - HA discovery (sensors, binary_sensors, switches, numbers); LWT availability - Static IP, firmware current clamps on seed and booster pump
42 lines
1.3 KiB
Makefile
42 lines
1.3 KiB
Makefile
# Koheron CTL200 -> WiFi/MQTT bridge on ESP32.
|
|
#
|
|
# All commands run PlatformIO from the project-local venv, so you never need
|
|
# `pio` on your PATH. Just `make`, `make upload`, `make monitor`.
|
|
|
|
VENV := .venv
|
|
PIO := $(VENV)/bin/pio
|
|
PORT ?= /dev/ttyUSB0
|
|
ENV := esp32dev
|
|
|
|
.PHONY: help build upload monitor flash clean detect erase venv
|
|
|
|
help: ## Show this help
|
|
@grep -E '^[a-zA-Z_-]+:.*?## .*$$' $(MAKEFILE_LIST) \
|
|
| awk 'BEGIN{FS=":.*?## "}{printf " \033[36m%-10s\033[0m %s\n", $$1, $$2}'
|
|
|
|
build: $(PIO) ## Compile firmware
|
|
$(PIO) run -e $(ENV)
|
|
|
|
upload: $(PIO) ## Compile + flash to the ESP32
|
|
$(PIO) run -e $(ENV) -t upload --upload-port $(PORT)
|
|
|
|
monitor: $(PIO) ## Open serial monitor (Ctrl-C to exit)
|
|
$(PIO) device monitor --port $(PORT) -b 115200
|
|
|
|
flash: upload monitor ## Upload then immediately open the monitor
|
|
|
|
detect: $(PIO) ## Identify the chip on $(PORT)
|
|
$(VENV)/bin/python -m esptool --port $(PORT) chip_id
|
|
|
|
erase: $(PIO) ## Erase entire flash (factory reset)
|
|
$(VENV)/bin/python -m esptool --port $(PORT) erase_flash
|
|
|
|
clean: $(PIO) ## Remove build artifacts
|
|
$(PIO) run -e $(ENV) -t clean
|
|
|
|
# Recreate the venv if it is missing (e.g. fresh checkout).
|
|
venv $(PIO):
|
|
python3 -m venv $(VENV)
|
|
$(VENV)/bin/pip install --upgrade pip
|
|
$(VENV)/bin/pip install platformio esptool
|